The controller divides the main oil flow (E) from the pump into two separate outputs that can supply two independent hydraulic systems (consumers). One output is priority (P), where the flow rate is regulated. Output B can also feed another consumer, but the flow on this output can fluctuate depending on the pump capacity.

General information:

Maximum flow rate: 80L/min

Flow control range per motor: 0-60L/min (max. 60L/min)

Number of hydraulic holes in the body: 3

Internal threads in the body: 1/2’

Permissible maximum pressure: 350bar

Body material: galvanised steel

Permissible ambient temperature: -40C to +60C

Permissible oil temperature: -15C to +80C

Fluid type: mineral oil based hydraulic oil

Connection:

– the main feed stream is connected to port E

– the working flow to the receiver is connected from port P

– the second working jet from port B is connected to the tank.

– The P/B flow division ratio is adjusted by means of a knob